THIS ITEM REQUIRES CERTAIN LEVEL OF KNOWLEDGE DURING INSTALLATION.
This 6 Ohm, 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb.
This will solve LED related turn signal problems such as hyper flashing, no flashing or burned out bulb indications.
One resistor is required for each turn signal bulb
- Brand new and high quality
- Can be used with vehicle turn signal light's LED conversion
- Solve hyper flash or no blinking of turn signal
- Each LED bulb installation requires one resistor connected in parellel (see picture below for instruction)
- Solution for "bulb out signal" / "OBC error message" after installing SMD LED light bulb
- Solution for fast turn signal blinking response after installing SMD LED light bulb
Can be used with LED turn light of cars
Excellent heat dissipation
With wire at each end of the resistor, easy to install
Resistance: 6 ohm
For 12 volts
Type: One LED resistor is required for each turn signal bulb or each license plate light bulb.